Always drain the coolant into a sealable container. This will prove fatal in sufficient quantity. It is not necessary to remove the radiator hose from the thermostat housing when removing the thermostat.ĬAUTION When draining the coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or in puddles on the ground. The thermostat is located inside a housing on the back of the cylinder head. GM Corsica/Beretta 1988-1996 Repair Guide plz vote comment and reply if need more help.i hope this is what you are looking for.Tighten the cover mounting bolts to 7 ft. Install the cover to the body with the follower pawl tabs aligned with the non toothed portions of the body. Place a new gasket into position on the cover. Set the control handle and clutch to the free position. (18 Nm).Īpply multi-purpose grease to the inner hub splines. Install the bolt with washer, tighten to 13 ft. The free wheeling hub body with the cones washers and nuts. Place a new gasket into position on the front axle hub. The free wheeling body should come off easily be sure to discard the old gaskets Using a brass bar and hammer, tap on the bolt ends. Using a brass bar and hammer, tap on the bolt ends, then remove the cone washers. Next, remove the outside mounting nuts and washers
Remove the cover mounting bolts, then pull off the cover. With the handle in the free position, remove the six hub cover bolts Note the directions in which you can turn the handle: left-free, right-lock
Turn the handle with your hand to the free position
0 kommentar(er)
